Natural Stone Sealer - 'WET LOOK' finish - Protective Stone Sealer to Enhance Colouring on Natural Stone, Gives a Durable, Clear Finish

£74.95
inc VAT
Please select a size
In Stock In Stock

Customer Reviews

There are currently no reviews for this product.

Be the first to write a review.

Leave A Review

Product Rating  *  *  *  *  *

*All submissions will be checked by our administration team before appearing on the site. Please be patient as we will try and approve your comments as quickly as possible.

Description

Smartseal Natural Stone Sealer WET LOOK is a water-based protective sealer that creates a durable, clear silk/satin finish. It can be used on internal and external surfaces made from sandstone, limestone, slate, terracotta, quarry and Victorian tiles, brick pavers and any textured stone or masonry surfaces.

Smartseal Natural Stone Sealer WET LOOK is rapid drying and very easy to apply. It will provide protection to the applied surface against oil and water-based stains. WE DO NOT RECOMMENDED USING ON HIGHLY POLISHED STONE & CERAMIC GLAZED SURFACES.

  • Ideal for Natural Stone & Slate
  • Provides a Silk/Satin or "Wet-look" finish
  • Ok for rough & absorbent surfaces
  • Colour enhancing effect of original surface colouring
  • Suitable for outdoor or indoor use

Please take a look at the other sealers for natural stone such as the DRY finish Natural Stone Sealer. For a colour enhancing sealer for natural stone that is not a gloss finish, you might want to consider the Natural Stone COLOUR ENHANCER.

 

Technical

COVERAGE RATIOS: 

Up to 15m per litre depending on the texture and porosity of the surface being sealed.

APPLICATION INSTRUCTIONS:

1. Apply in temperatures above 15C, ensuring the surface is completely dry, clean and free from debris. Apply only if no rain is forecast for at least 8 hours. For best cleaning results use Patio Clean Xtreme.

**If applied to a surface where a "sweep-in" pointing compound has been used with the last 6 months, the natural stone must be fully cleaned with Smartseal Residue Remover prior to sealant application.**

2. Apply the sealer thinly and evenly with a low pressure sprayer, roller, microfibre mop, paint brush or soft cloth. Try not to leave application marks or allow the product to 'pool' or 'puddle' on the surface immediately after application. In the event of over application please ensure all excess is removed within 45 minutes of applying.

3. Once applied, allow approximately 45-60 minutes drying time before applying the second coat. After 45-60 minutes, repeat the process and apply the product in the opposite direction to try to achieve an even finish. Multiple coats can be applied to achieve the desired finish.

Important Note:  Any areas nearby that are not being sealed should be protected with masking materials. If you are sealing over coloured grouts, carry out that a stain test before proceeding.

 
×